Multi-Objective Function Optimization for Locating and Sizing of Distributed ‎Generation Sources in Radial Distribution Networks with Fuse and Recloser ‎Protection

Document Type : Research paper

Authors

Department of Electrical Engineering, Saveh Branch, Islamic Azad University, Saveh, Iran

Abstract

Power quality, reliability, loss reduction, and fault clearing times are essential factors in distribution networks. Radial distribution networks often face two problems, line losses and voltage drop at the end of the grid. Connecting distributed generation (DG) can resolve these problems, but it can also cause miscoordination. Protection coordination in the presence of DGs is a major challenge of radial networks. Herein, the optimal location and size of DGs in a radial distribution network protected by fuse and recloser were determined to modify bus voltage profile and reduce active-reactive lines' losses. Since the protection coordinate was eliminated by connecting DGs to the network, by using the SFCL in the output of DGs and minimizing its size, it attempted to restore the protection coordination between the fuse and the recloser. In this method, a nonlinear multi-objective function was introduced to be optimized by genetic and PSO algorithms. The simulation was performed in DIgSILENT software. The effectiveness of the proposed method was verified via IEEE 33-bus test systems.

Keywords


[1]  M. Alilou, D. Nazarpour and H. Shayeghi, “Multi-objective optimization of demand side management and multi dg in the distribution system with demand response”, J. Oper. Autom. Power Eng., vol. 6, pp. 230-242, 2018.
[2]  S. Ghaemi and K. Zare, “A new method of distribution marginal price calculation in distribution networks by considering the effect of distributed generations location on network loss”, J. Oper. Autom. Power Eng., vol. 5, pp. 171-180, 2017.
[3]  M. Kazeminejad et al., “The effect of high penetration level of distributed generation sources on voltage stability analysis in unbalanced distribution systems considering load mode”, J. Oper. Autom. Power Eng., vol. 7, pp. 196-205, 2019.
[4]  P. Manditereza and R. Bansal, “Renewable distributed generation: The hidden challenges – A review from the protection perspective”, Renew. Sustain. Energy Rev., vol. 58, pp. 1457-1465, 2016.
[5]  M. Dashtdar, M. Najafi and M. Esmaeilbeig, “Reducing LMP and resolving the congestion of the lines based on placement and optimal size of DG in the power network using the GA-GSF algorithm”, Electrical Engineering, 2021.
[6]  A. Selim, S. Kamel and F. Jurado, “Efficient optimization technique for multiple DG allocation in distribution networks”, Appl. Soft Comput., vol. 86, pp. 105938, 2020.
[7]  J. Sa'ed et al., “An investigation of protection devices coordination effects on distributed generators capacity in radial distribution systems”, Int. Conf. Clean Electr. Power, pp. 686-692, 2013.
[8]  A. Ibrahim et al., “Adaptive protection coordination scheme for distribution network with distributed generation using ABC”, J. Electr. Syst. Inform. Technol., vol. 3, pp. 320-332, 2016.
[9]  S. Jamali and H. Borhani-Bahabadi, “Recloser time–current–voltage characteristic for fuse saving in distribution networks with DG”, IET Gener. Transm. Distrib., vol. 11, pp. 272-279, 2017.
[10]  N. Bayati et al., “A fuse saving scheme for DC microgrids with high penetration of renewable energy resources”, IEEE Access, vol. 8, pp. 137407-17, 2020.
[11]  M. Alam, B. Das and V. Pant, “Optimum recloser–fuse coordination for radial distribution systems in the presence of multiple distributed generations”, IET Gener. Transm. Distrib., vol. 12, pp. 2585-2594, 2018.
[12]  A. Esmaeili Dahej, S. Esmaeili and H. Hojabri, “Co-optimization of protection coordination and power quality in microgrids using unidirectional fault current limiters”, IEEE Trans. Smart Grid, vol. 9, pp. 5080-91, 2018.
[13]  M. Khademi, “Designing a coordinated protection system for microgrids enabled with DERs based on unidirectional FCL”, CIRED - Open Access Proc. J., pp. 1027-30, 2017.
[14]  S. Ghobadpour, M. Gandomkar and J. Nikoukar, “Determining optimal size of superconducting fault current limiters to achieve protection coordination of fuse-recloser in radial distribution networks with synchronous DG”, Electr. Power Syst. Res., vol. 185, pp. 106357, 2020.
[15]  G. Zhou et al., “Studies on the combination of RSFCLs and DCCBs in MMC-MTDC system protection”, Int. J. Electr. Power Energy Syst., vol. 125, pp. 106532, 2021.
[16]  E. Dehghanpour et al., “Optimal coordination of directional overcurrent relays in microgrids by using cuckoo-linear optimization algorithm and fault current limiter”, IEEE Trans. Smart Grid, vol. 9, pp. 1365-75, 2018.
[17]  R. Thute et al., “Line distance protection in the presence of SCFCL”, IET Gener. Transm. Distrib., vol. 13, pp. 1960-69, 2019.
[18]  H. Mahrous and M. Aly, “Protection coordination of radial distribution networks connected with distributed generation considering auto-reclosing schemes by resistive superconducting fault current limiter”, Int. J. Emerg. Electr. Power Syst., vol. 21, 2020.
[19]  F. Guarda et al., “Fault current limiter placement to reduce recloser and fuse miscoordination in electric distribution systems with distributed generation using multi-objective particle swarm optimization”, IEEE Latin America Trans., vol. 16, pp. 1914-1920, 2018.
[20]  A. Arafa, M. Aly and S. Kamel, “Impact of distributed generation on recloser-fuse coordination of radial distribution networks”, Int. Conf. Innovative Trends Computer Eng., pp. 505-509, 2019.
[21]  H. Zeineldin and W. Xiao, “Optimal fault current limiter sizing for distribution systems with DG”, IEEE Power Energy Soc. Gen. Meet., pp. 1-5, 2011.