A. Yaqoub Hamza; F.A. Jumaa
Abstract
In this paper, a novel high step-up voltage switching cell formed by four passive elements and three diodes is proposed. The proposed cell can be integrated into a family of boost converters to obtain substantial dc gain as required by an electrical grid supplied such as solar or fuel cell. It is integrated ...
Read More
In this paper, a novel high step-up voltage switching cell formed by four passive elements and three diodes is proposed. The proposed cell can be integrated into a family of boost converters to obtain substantial dc gain as required by an electrical grid supplied such as solar or fuel cell. It is integrated into a boost converter; a new converter is obtained. The features of a new converter are significant dc gain without extreme duty cycle which enables the use of lower voltage and R${}_{Ds-on}$ MOSFET switch so as to reduce cost, the low-stress voltage on the switch and diodes, non-pulsating input current, easiness design and operation, single switch which means easiness of transistor driving, and line-load common ground. In addition, the low-voltage stress across diode allows using Schottky rectifiers to eliminate the reverse recovery current which leads to more reduction in conduction and switching losses. The equations of voltage and current in "continuous conduction mode (CCM) and discontinuous mode (DCM)" are extracted. Moreover, the voltage and current stresses on elements and switch are calculated. Finally, the performance of the proposed converter is validated by simulation results and experimental results to confirm theoretical calculation.
