Power Electronic
M. R. Banaei; H. Ajdar Faeghi Bonab; N. Taghizadegan Kalantari
Abstract
In this paper, a new transformerless buck-boost converter based on ZETA converter is introduced. The proposed converter has the ZETA converter advantages such as, buck-boost capability and input to output DC insulation. The suggested converter voltage gain is higher than the classic ZETA converter. In ...
Read More
In this paper, a new transformerless buck-boost converter based on ZETA converter is introduced. The proposed converter has the ZETA converter advantages such as, buck-boost capability and input to output DC insulation. The suggested converter voltage gain is higher than the classic ZETA converter. In the presented converter, only one main switch is utilized. The proposed converter offers low voltage stress of the switch; therefore, the low on-state resistance of the main switch can be selected to decrease losses of the switch. The presented converter topology is simple; hence, the control of the converter is simple. The mathematical analyses of the proposed converter are given. The experimental results confirm the correctness of the analysis.
Power Electronic
A. Ghaemi; M. R. Banaei; A. Safari
Abstract
One of the most efficient lighting technology is based on light-emitting diodes (LEDs). Common LED drivers with AC-input (50-60Hz) usually require a bulk electrolytic capacitor to decrease low-frequency ripple in the output. However, the critical element that limits the lifespan of the LED driver is ...
Read More
One of the most efficient lighting technology is based on light-emitting diodes (LEDs). Common LED drivers with AC-input (50-60Hz) usually require a bulk electrolytic capacitor to decrease low-frequency ripple in the output. However, the critical element that limits the lifespan of the LED driver is the electrolytic capacitor. An isolated off-line LED driver is proposed in this paper, in which the required output capacitance is reduced so that the electrolytic capacitor can be omitted from the driver structure. The driver’s configuration and controlling method provide a high input power factor. Just a single switch and therefore a single controlling IC have been used in the proposed structure. The input power factor correction is implemented utilizing a boost-based method, and a novel structure is introduced for dc/dc conversion section. Power factor correction and dc/dc conversion are performed employing a simplistic and single controlling system. The output current feeding the LEDs is a high frequency pulsating current. Calculations, simulations and experimental waveforms of a laboratory prototype are presented to confirm the validity of the proposed driver.
Power Electronic
R. Esmaeilzadeh; A. Ajami; M. R. Banaei
Abstract
This paper proposes a new two-stage inverter based on transformer-less high gain DC-DC converter for energy conversion of a photovoltaic system. The designed system consists of a high gain DC-DC converter cascaded with a three-phase inverter. The proposed DC-DC converter has a simple structure, and it ...
Read More
This paper proposes a new two-stage inverter based on transformer-less high gain DC-DC converter for energy conversion of a photovoltaic system. The designed system consists of a high gain DC-DC converter cascaded with a three-phase inverter. The proposed DC-DC converter has a simple structure, and it has one switch in its structure. The output voltage of the DC-DC converter supplies DC source for the inverter part of the multi-stage inverter. The advanced two-stage inverter sample was fabricated, then the findings of the acquired simulation and hardware warranted the configuration applicability. Finally, the MATLAB/SIMULINK is employed for the simulation of PV-battery system. The obtained results revel that the proposed power conversion system effectively chases the load and generation fluctuations and also properly handles the power mismatches in PV-battery system.
Power Electronic
E. Salari; M. R. Banaei; A. Ajami
Abstract
A non-isolated DC/DC converter with high transfer gain is proposed in this paper. The presented converter consists of the switched inductor and three-level converters. The DC/DC power converter is three-level boost converter to convert the output voltage of the DC source into two voltage sources. The ...
Read More
A non-isolated DC/DC converter with high transfer gain is proposed in this paper. The presented converter consists of the switched inductor and three-level converters. The DC/DC power converter is three-level boost converter to convert the output voltage of the DC source into two voltage sources. The main advantages of DC/DC converter are using low voltage semiconductors and high gain voltage. The steady-state operation of the suggested converter is analyzed. A prototype is developed and tested to verify the performance of the proposed converter. To sum up, the MATLAB simulation results and the experimental results have transparently approved high efficiency of proposed converter as well as its feasibility.
Power Electronic
A. Baghbany Oskouei; M. R. Banaei; M. Sabahi
Volume 4, Issue 2 , December 2016, , Pages 132-142
Abstract
This paper combines quasi-Z-source into a typical five-level inverter, which includes two dc voltage sources, two quasi-Z-sources and five switching devices. In this structure, the output voltage amplitude is not limited to dc voltage source and it can be increased by quasi-Z-source. Besides, due to ...
Read More
This paper combines quasi-Z-source into a typical five-level inverter, which includes two dc voltage sources, two quasi-Z-sources and five switching devices. In this structure, the output voltage amplitude is not limited to dc voltage source and it can be increased by quasi-Z-source. Besides, due to nature of Z-source families, this new structure is reliable and higher efficiency. Also, in this inverter, two quasi-Z-networks can be controlled independently. This paper also proposes new switching algorithms for proposed five-level dual quasi-Z-Source inverter based on pulse width modulation (PWM) and selective harmonic elimination method (SHEM) algorithms .The performance of proposed inverter and switching algorithm are validated with simulation results using MATLAB/SIMULINK software and experimental results based PCI-1716 data acquisition system.
Power Electronic
Mohammadreza Banaei
Volume 4, Issue 1 , June 2016, , Pages 42-53
Abstract
This paper proposes a multi-stage power generation system suitable for renewable energy sources, which is composed of a DC-DC power converter and a three-phase inverter. The DC-DC power converter is a boost converter to convert the output voltage of the DC source into two voltage sources. The DC-DC converter ...
Read More
This paper proposes a multi-stage power generation system suitable for renewable energy sources, which is composed of a DC-DC power converter and a three-phase inverter. The DC-DC power converter is a boost converter to convert the output voltage of the DC source into two voltage sources. The DC-DC converter has two switches operates like a continuous conduction mode. The input current of DC-DC converter has low ripple and voltage of semiconductors is lower than the output voltage. The three-phase inverter is a T-type inverter. This inverter requires two balance DC sources. The inverter part converts the two output voltage sources of DC-DC power converter into a five-level line to line AC voltage. Simulation results are given to show the overall system performance, including AC voltage generation. A prototype is developed and tested to verify the performance of the converter.
